Videos & Galleries

Video: Tricks & Tools to Pressure Lube a Modern Engine

Priming a new engine prior to first start-up is really, really, really important (really). This video from Jeff Smith will show you how to do it on a newer engine. (Image/Jeff Smith’s YouTube Channel)

Recently, we ran an article on knowing the difference between oil pump primers. While the story focused on earlier V8s with distributor-driven oil pumps, we also touched briefly on modern engines and engine prelubers. And that’s an important distinction, because newer engines (like the GM LS, Gen III. Hemi, and Ford Mod Motor) don’t have distributors and instead use different oil pump designs.

So after the article was published, a few folks mentioned that they’d like to see a more in-depth look at how to prime and prelube a modern engine.

Enter OnAllCylinders contributor Jeff Smith. His YouTube Channel, Jeff Smith’s Garage, is packed with informative videos. And, lo-and-behold, he’s got a really good one on how to prime and pressure-lube a late-model V8 motor.

Check it out below and if you like what you see, don’t forget to subscribe to his YouTube channel.

Tags: , , ,

3 Comments

  1. Mike+Brown says:

    Even though I don’t have any distributorless engines that I plan on building right now, I’m sure that I will eventually. I currently have a stash of gutted distributors that I use as primers. However, I’ve always wondered how you prime a fresh engine that doesn’t have a distributor. Thanks for the video.

  2. Pingback: Stuff from D. April 18th, 2021 – Darryl's Drive In

  3. Tom Paffrath says:

    Thanks for the heads up. Good video’s.

Leave a Reply to Mike+Brown Cancel

Your email address will not be published. Required fields are marked *

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.