Engine & Exhaust / Q&A / Tech

Mailbag: Rebuilding a Chevy 454 for Nitrous Oxide Use

BBC 454 with nitrous by Classic Cars from UK

(Image/Classic Cars from UK)

You’ve got questions, we’ve got answers. We work with the Summit Racing tech department to help you tackle your auto-related conundrums. In this week’s Mailbag, we’re rebuilding a big block Chevrolet engine to work with a nitrous oxide system

Q: I have a 1973 El Camino with a factory 454 big block. I have updated it with a COMP Cams roller cam (.623/.651 inches of lift) with matching lifters and valve springs, roller rocker arms, a Weiand Team G intake with a 750 cfm Holley carb, MSD Pro-Billet distributor and 6AL ignition, and Hooker headers with three-inch dual exhaust and Flowmaster mufflers. The transmission has a trans-brake and a 4,500 rpm stall converter.

I want to rebuild the engine for use with nitrous oxide. Will I need to change the pistons and rings? Will the stock connecting rods be OK? I was thinking about getting a new set of cylinder heads and perhaps a gear drive. Finally, what rear axle gear ratio should I use with this new engine combination? The car will be used at the track and as a Sunday driver.

A: Here’s what we’d recommend for your big block:

1. Cylinder Heads

If your engine will operate below 6,800 rpm and make less than 570 horsepower, use Edelbrock Performer oval port heads. For an engine making over 570 horsepower and running above 6,600 rpm, use the Performer rectangular port heads. Beyond 7,200 rpm, consider using World Products Merlin cylinder heads.

2. Pistons and Rings

With the oval port heads, use a Speed Pro forged piston with Sealed Power file-fit rings. The piston has a .225-inch dome and will yield around 10.5:1 compression. If you use the rectangular port heads, go with a TRW-L2372AF forged piston with SLP-R-9334 file-fit rings. If you take about .180 to .200 inches off the domes of these pistons, you will get 10.5:1 compression.

3. Connecting Rods

The factory forged rods will be fine up to 7,000 rpm when properly prepped, including new bolts. If the engine will be operated at 6,000 rpm or less, use 7/16-inch bolts. Beyond seven grand, use an aftermarket rod like a Manley or a Lunati.

4. Gear Drive

Unless you have a high-dollar, lightweight valvetrain, you don’t really need a gear drive. We would use a good timing chain set like a Cloyes true roller.

5. Rear Axle Gear Ratio

Your car can’t be used as a highway cruiser due to the high-stall torque converter, so you can go bigger on the gear. We’d recommend a gear ranging from 3.90 to 4.56 depending on tire height.

Tags: , , , ,

3 Comments

  1. JIMMY BLAZER!!!! says:

    1995 SUPER CHARGED 98 OLSMOBILE OR !((!@#% POWER.

  2. Beef it up, forged pistons and mega valve train. then go over the drive train with the same attitude.
    Let er rip when you flip the switch.

Leave a Reply to JIMMY BLAZER!!!! Cancel

Your email address will not be published.

*

This site uses Akismet to reduce spam. Learn how your comment data is processed.