Induction

Q: My car is a 1984 Pontiac Bonneville with a 500 cubic-inch Cadillac engine. The engine is bored .030″ over and uses flattop pistons and Cadillac 425 heads for a […]

Q: My 1969 Chevy Camaro has a brand new 377 cubic inch small block, a Turbo 350 transmission (4,000 rpm stall), a 12-bolt rear-end with 4.11 gears, an MSD 6AL […]

Can I put a blower on my balanced and blueprinted 383 c.i.d. stocker motor that has 10:1 compression? I just want it for looks, not to race. – G.H. … […]

In part one of this two-part segment, we dug into Holley Performance Product’s top-of-the-heap Dominator EFI system. If you recall, we noted how sophisticated this system is and how user friendly […]

Q: I have a Gen. Five, LT-series 5.3L L83 engine that’s going into my 1975 Chevy Monza. The factory intake manifold is too tall to clear the stock hood, so […]

I’m building an LS engine to put into an early Chevy pickup and I’ve got a fuel delivery system question. I’m running one of those new Holley Sniper aluminum fabricated […]

It’s no secret that aftermarket electronic fuel injection (EFI) systems are becoming more and more commonplace. It should come as no surprise however, that some of the early systems were […]

Q: I have a 1981 Pontiac Firebird with a Chevy 350 in serious need of some more low-end power! It has a Holley Dominator manifold and a 750 cfm car, […]

I’ve heard there is a really good factory LS intake manifold out there for cathedral port intakes but the friend who mentioned it didn’t know anything more than that. He […]

Q: I own a 1986 Ford Bronco 4×4 with a 302 V8, electronic fuel injection, and a C-6 automatic transmission. The body is banged up and rusted beyond repair. I […]