Wiseco-Piston-Rings

(Image/Wiseco)

Piston rings have a dictionary all to themselves, and it’s important to be familiar with the terms before you begin an engine build.

The piston pros at Wiseco put together this short glossary of important piston ring terminology so you’re in the loop…err…ring, when it’s time to install your pistons.

Piston Ring Glossary of Terms

Axial Clearance

The distance between the ring axial height and the piston ring groove width.

Axial Height

The width (thickness) of the ring in the axial direction.

Back Clearance

Distance between the inside diameter of the ring and the back of the ring groove when the ring is flush with the ring land.

piston measurements

D-Wall

A specification established by the Society of Automotive Engineers (SAE) that dictates the radial width of a standard automotive piston ring using this formula:

D-Wall: Bore diameter divided by 22 = radial thickness

(for example, 3.386″ / 22 =.154″)

End Gap

The end gap clearance when the ring is compressed to the bore diameter.

Gas Nitrided

A process used to harden the perimeter of a ring where nitrogen atoms penetrate the base material and form an extremely hard outer layer that provides excellent wear and scuff resistance.

Neutral Barrel

A term used to describe a piston ring that has no torsional bias or twist.

Neutral-Barrel Piston Ring

Positive Twist

An asymmetric change in the ring cross section that causes it to twist in an upward direction (toward the piston crown) aiding ring sealing of the top and bottom of the ring groove. Positive twist is used only on top compression engines.

Positive-Twist Piston Ring

Reverse Twist

An asymmetric change in the ring cross section causing the ring to twist downward (toward the piston skirt) that enhances the second compression ring’s oil scraping properties.

Radial Width

The ring width in the radial direction.

Ring Axial Sides

The top and bottom surfaces of the ring.

Ring Face

The section that contacts the cylinder wall.

Torsional Twist

The installed position of the ring due to a chamfered area on either ring side that helps the ring cross-seal.

 

Share this Article